What happened
GYROPLANE: Do not forget to check that the propeller blades all have the same pitch!Back from the TOUR ULM 2015, I would like to share an unfortunate – but instructive – experience that hampered me throughout the Tour. At Merville, taking off again in my 912S gyroplane, two on board with full tanks: on the grass runway I had great difficulty getting off the ground despite a strong, favourable wind! I drifted sideways without the wheels leaving the ground! I tried twice more with the same result, so much so that I pulled over to the side, thinking I had flat tyres or binding brakes!
Jack kindly asked me to go back to the base to check my engine and the machine. With the help of several pilots I checked the engine power statically = difficulty getting above 5 200 rpm, whereas I normally reach 5,400 rpm on take-off. After taking advice, I decided to take off again alone, successfully (without my wife, who unfortunately had to follow in the “sweeper” car).
After the emotion and some reflection, I remembered that at every stage I had had more or less difficulty taking off and had often used the full length of the runway, ever since Guiscriff – something I had never experienced in my 3 years as a student pilot!
When I got back from the Tour, my instructor, whom I had informed a few days earlier, quickly found the problem: one of the propeller blades had a different pitch from the other two, which was costing me the 200 300 rpm I was missing on take-off. As soon as he corrected it, everything went back to normal, with full engine power.
Just before the Tour I had given the aircraft a thorough check, without thinking of checking that the propeller blade pitch was consistent! Now I need to find out why one of them moved!
Pilot's comments
No, on the spot I had not understood what was happening.Lessons learned:
Yes, the mistake was not checking that the engine was not reaching its maximum of 5400 rpm.















