What happened
I had made a long 400 km trip. The next day, during the pre-flight check, I noticed that the spark plug cap was off. So I had flown 400 km with 1 spark plug missing!Worse, when checking the other spark plugs, another one was not properly secured. I was within a whisker of an engine failure!
During the flight I had noticed a slight loss of power at one point, which was certainly when the failure occurred, but as it did not get worse I continued the flight, paying closer attention to emergency landing fields.
In the end everything went well, which is why it was only the next day that I realised how serious the problem was.
Pilot's comments
I underestimated the problems that can arise from wear on the spark plug terminals (nobody had mentioned it to me) with an inverted engine configuration.Still, I think it is positive that I was attentive enough to notice a very small loss of power in flight, corresponding to a spark plug becoming disconnected, and that once again I made the best decision: deciding that I could finish the flight on one spark plug while being more vigilant.
Lessons learned:
I draw 2 lessons from this:
1- Check the condition of the spark plug caps and of the aluminium spark plug terminals (which can unscrew or pull off). Checking the caps and retightening the terminals at every pre-flight inspection had also worn them. My engine is mounted inverted, which increases wear on the spark plug terminals and lets the caps come off completely if they are worn. So particular care is needed with this configuration. I now prefer to secure them with Loctite threadlocker so that they cannot unscrew, or wear and then come loose with vibration. It seems to work well and I no longer have any wear on the spark plug terminals. I still check the spark plug caps by removing them, because that is the only way I was able to see that my second spark plug was on the verge of coming off, but I remove them without any twisting motion.
2- It was the small reduction in power that made me more vigilant. I did not have a failure, but I was ready. So I always stay alert to the slightest change in engine rpm and engine noise (perhaps a little too much).
I tell myself that no current regulation could have prevented this and that, in part, it was the checks themselves that became the cause of the problem. So you must be very vigilant about minor things, and pragmatic.















