Skip to content
French Microlight Federation Member
Home
Flying Entry to the Flying section

Fly

What is microlighting?Where to fly?Licence and insuranceMedicalHandivolMechanics

Become a pilot

The pilot certificateMicrolight examTrainingTrial flight

Regulations

Regulatory documentsAirspacePlan your flightsAirfieldsOPS ULM — order of 17/02/25

Federation support

Aides jeunesLe BIASubventionsFormation Accompagnant en Vol
Instruction Entry to the Instruction section

Network

Clubs and schoolsInstructors

Instructors

Microlight instructor trainingList of instructors by départementKnowledge refresherThe teaching programmeTeaching and technical sheets
Sport
Safety Entry to the Safety section

Prevention

DirectivesParachutesFederation prevention

Safety reports

REX — submit and browseFlight Safety BulletinReturn to Flying (REV)ECCAIRSCSV flight safety officersList of REX reports

Alerts

Safety news

Files and quizzes

Good practice
News Entry to the News section

Read

Federation newsULM Info — the magazineClub and school life

Calendar

EventsSubmit an eventFederation events

Media

Photos & VideosDocuments to downloadPractical guides

Stay informed

Frequently asked questions
The Federation Entry to the Federation section

The institution

Elected membersThe divisionsRegional committeesThe DTNEthics and professional conductSafeguarding in microlightingThe federation in figuresOfficial textsGeneral Assembly

Federation events

The Youth Microlight Tour (Tour ULM Jeunes)Microlight World ChampionshipsFesti'ULM

Join us

RecruitmentContactReport
Site map

SafetySafety report

Onboard system failure disrupting flight management

During a series of circuits after maintenance work on the microlight, I noticed that the aircraft tended to veer to the left when rolling out after landing.

REX no. 7124
Year
2016
Weather
Favourable
Damage
No
Aircraft
Three-axis microlights
Date of flight
12/03/2016
Role on board
Pilot
Event type
Onboard system failure disrupting flight management
REX category
Caution
Phase of flight
taxiing after landing
Type of flight
a local flight
Equipment
Parachute, Radio, Distress beacon, GPS
Possible consequences
Runway excursion, Collision on the ground

What happened

During a series of circuits after maintenance work on the microlight, I noticed that the aircraft tended to veer to the left when rolling out after landing. At first I put this tendency down to my lack of recent practice with the crosswind component affecting the track, and I took off again promising myself to be more careful. The next two circuits went well and I decided to do a full-stop landing.
After this last flare, the microlight again veered very sharply to the left although the wind had clearly dropped, to the point of forcing me to apply right rudder almost to the stop to avoid leaving the runway.

Pilot's comments

My aircraft has a hydraulic braking system with a lever on the stick that acts on both wheels at the same time. I realised that I had used it moderately on the first landing, to give another aircraft time to taxi into position to take off behind me, but that I had not then used the brake during the next two touch-and-goes.
On the other hand, as the last landing was a full stop, I applied the brake to slow down. What prevented me from understanding straight away what was happening was that the pull to one side became obvious not when I braked, but in fact when I released the lever.
Lessons learned:
The maintenance work on the microlight had included removing the brake callipers to replace the pads. When refitting them, I routed the two hydraulic hoses slightly differently, with the one on the right undercarriage leg passing in front of its strut and the one on the left behind its own. I knew this, but I thought it did not matter. I should have been more rigorous, because this arrangement actually caused a slight pinching of the left hose where it passes through the fuselage, impossible to see from outside but obvious when looking under the seat. Under braking, there was no real noticeable difference in how firmly the right and left brakes gripped. However, when I released the pressure, there was a real delay between the two brakes releasing. The kinked hose had to be replaced. To be sure of not causing any further imbalance, I chose to replace all the brake lines.

They support the federation

All our partners
  • Ministry of Ecological Transition
  • DGAC
  • Ministry of Sport and the Olympic Games
  • National Sports Agency
  • CNFAS
  • FAI
  • Aéro-Club de France
  • CNOSF
  • EMF
  • Air and Space Museum