What happened
Numerous engine misfires since changing from SP98 to SP98E5. Water in the carburettor bowls, despite draining the low point of the fuel system before every flight. Early signs of icing were stopped by carburettor heat and by raising engine speed.On final at my aerodrome, with the engine at idle, it stalled and there was no time to restart it. Landing without damage.
Since then, regular removal of the carburettor bowls shows many beads of water. My fuel is not stored and I fly 1 to 2 times a week.
This is therefore linked to the poor quality of SP98E5 and its uncontrollable water content; in my view, the other possible causes of failure were ruled out by a federation mechanic. I am also going to replace my aircraft's drainable low-point reservoir with a settling tank, but will that be enough? Please note that I am far from any station with UL91.
Pilot's comments
Yes. First, rule out any other cause of failure. Then check the carburettor float bowls regularly, which is tedious all the same (out of caution, I did it before every flight). And then, replace my low-point header tank with drain by a sediment bowl. And finally, be prepared for an engine stoppage... forewarned is forearmed.Lessons learned:
No particular mistake.
Lesson: today's fuel, even SP98 E5, is not reliable for our microlights. So be careful.















