What happened
During the pre-flight, I noticed that the starter cord was very slightly worn at the small metal ring where it leaves the starter. Without worrying more than I should, I thought I would need to replace it, but that there was still enough thickness of cord before it frayed.
After about 2 hours 30 of flight, a jolt combined with a loud noise? I picked out a field where I could possibly land. The engine was running normally, the microlight was flying without problem. Once the stress had passed, my passenger and I looked for what had caused the noise; without doubt, something had gone through the propeller. Turning round, I saw that the starter handle was no longer there?
The cause was of course the breaking of the cord. After examination, the metal ring at the starter outlet turned out to be oxidised and, helped by vibration, had cut into the cord until it broke, helped also by the fact that the cord comes out at an angle between the starter and the pulley on the mast.
Fortunately the propeller was only slightly damaged on the trailing edge of one blade, without generating vibration, which allowed me to land at Montpezat airfield a few 15 km away, repair it and continue my flight. The propeller was then overhauled and repaired by its manufacturer.
Pilot's comments
The conclusion is obvious: let nothing slide; the slightest defect noticed on a microlight must be corrected without delay.
Federation analysis
Leaving no room for doubt and replacing parts that look degraded remains a good solution.















