What happened
Technical problem with the trim tab on the microlight's elevator
Phase of flight: initial climb
Description of the event:
Friday morning, 08:00 preparation for a short navigation flight of 01:30 maximum. Pre-flight inspection of engine, structure, tyres, etc.: nothing to report.
Take-off at around 09:00, runway 33, progressive application of power, safety level-off and initial climb. 3 to 4 seconds later, strange shaking begins: the stick goes from nose-down to nose-up without stopping. I hold the stick while trying to understand what is happening; I act quite quickly on the brake handle to rule out a wheel cause, no change; a quick glance to the side and I see that I am still climbing normally; I reduce by about 300 rpm to try to limit the shaking at the stick; a quick glance at the altimeter: 1600 feet.
At 1900 feet, right turn and reduction to 3900 rpm for a tight circuit, and a radio call that I have a problem with the machine and am coming back to land.
Reducing speed makes the problem disappear. I fly my base leg and final normally.
Pilot's comments
In the hangar, I find that an assembly made up of a metal part and the trim control cable was no longer attached to the elevator trim tab; the 3 retaining rivets had given way.















