What happened
Before carrying out the engine run-up at the holding point, I notice that the electrical services are off.
Alone on the aerodrome, and to limit time pressure, the engine is shut down.
I carry out fault-finding using the acronym CRAPS (Control, Reset, Power supply, Protections, Signalling) defined in the ENAC instructor guide.
The cockpit electrical protections are checked by visually inspecting the condition of the Master fuse: not blown, but a contact pin that may be slightly bent.
This fuse is put back in place.
I carry out a FORDEC and decide to make the flight, which goes without incident.
After the flight this intermittent failure reappears on the cleared runway. The same fault treatment is used without success, with a temporary fuse swap, again without success.
At the parking area, engine off, a check to remove doubt is done by removing and refitting the Master fuse: a poor contact is suspected.
The problem is logged on Aerogest, to which our mechanic has access, for maintenance action.
The next microlight pilot is informed verbally and via Aerogest of the decision and decides to make his flight subject to the electrical services working on the ground.
Pilot's comments
The operating conditions were checked using a recognised method.
The decision to make the flight was taken after a structured assessment, as was the decision not to ground the machine after this intermittent failure.
As the event did not affect the airworthiness of the aircraft and the microlight mechanic reported no APRS on the aircraft logbook, the club management and the pilots with access to the machine were informed via the Aerogest software.















